Before preparing a board for modules, verify its perpendicularity, dimensions and straightness.

The exterior panels must be cut using well-sharpened, hard tools (tungsten carbide/Widia), and at all times you should prevent said tools from heating.

· Types of blade:

- Wood-cutting saw blades.

- Hard material (Widia tip).

· Placing the board:

The cutting blade must always enter from the board’s good side.

- Table-mounted saw: the visible side of the board must be facing upwards.

- Hand-held saw: the visible side of the board must be facing downwards.

Approximate parameters for saw blades, according to the type of tool:

Height of the cutting blade:

In order to achieve a clean cut on the exposed side, we recommend the cutting blade stands out approximately 1-2 cm from the material to be sawn.

After cutting:

After machining (sawing, drilling, milling, bevelling, sanding, and maybe polishing) there is no need for the obtained surfaces to undergo any finishing or protection treatment. Sharp edges may be smoothed down with sandpaper.